NCache allows you to remove an existing cache. You can remove a cache without stopping any of the existing caches on this server.
An already registered cache can be removed using the following steps.
For NCache Community and Open Source Editions, you can manually edit config.ncconf and client.ncconf located at %NCHOME%/config. %NCHOME% is NCache install directory. These files can be edited through any text editor of your choice.
Step 1: Remove Cache Configuration from All Nodes
In order to remove a existing cache on a server, remove the entire configurations of that particular cache from config.ncconf of each server node (in case of clustered cache) and the local server (in case of local cache).
In the sample configuration below, the cache named demoClusteredCache is removed by removing the associated configurations of the
cache-name in your configuration will be the name of your own cache to be removed.
<cache-config cache-name="demoClusteredCache"> ... </cache-config>
Repeat this step for all server nodes in case of replicated and partitioned cache.
Step 2: Restart NCache Service on All Nodes
For the configuration changes made to take effect, restart NCache Service using Windows PowerShell. Make sure you have enough privileges to restart the service. If the user is not the part of the Administrator's group, make sure to run Windows PowerShell as administrator, otherwise you might get an error message that "Cannot open ncachesvc service on computer".
Execute the following command to restart NCache Service:
Restart-Service -Name NCacheSvc
Repeat this step on all cache server nodes in case of partitioned and replicated cache.
Step 3: Remove cache from client.ncconf
Once the node is removed from config.ncconf, you need to update client.ncconf. In client.ncconf of EACH server node, remove the entire
<cache> configuration associated to the cache.
<cache id="demoClusteredCache..."/> ... </cache>
Please refer to the Remove Client from Cache section for more detail.
Step 5: Verify Successful Cache Removal on All Nodes
In order to verify the successful removal of the cache, use Windows PowerShell to run the Get-Caches command to get the list of the registered caches on the server. Successful removal of the cache will be verified if the cache list displayed does not contain the cache name.